How To Setup Your Macard WiFi Extender Correctly Android
Macard WiFi extenders can change the game, but it's important to set them up correctly on your Android device for maximum performance. This guide will help you control your Wi-Fi coverage at home.
Set Up Your Macard WiFi Extender via Android
Plug the Macard extender in a power outlet close to your router. Wait until the Power LED turns solid (usually between 1-2 minutes).
You can connect your device using the default SSID credentials on the label. To connect:
Go to Settings > Wi-Fi on your Android device.
Search for network names such as Macard_EXT or WiFi_Repeater.
Tap to connect. No password is required.
Follow the instructions below to configure your Macard WiFi extender via your web browser on your smartphone:
Via the Web browser on your phone
Open any browser in your Android. Type the IP address of your Android device in the address bar and hit Enter. The Macard setup page will open.
The default Macard login credentials are:
Username: admin
Password: adminSelect Extender Mode or Repeater Mode on the dashboard. The app will search for WiFi networks nearby.
The extender will look for Wi-Fi networks nearby. Select your home WiFi network. Enter the password of your home Wi-Fi.
You can choose to keep the name of your router's Wi Fi, such as "-EXT", or you can select a different name.
Click the Save button once you have configured all necessary settings. It is likely that the extender will restart in order to apply settings and complete setup.
Connect Android again with Extender's Network
Go back to your Android device's Wi-Fi settings after the extender has restarted. Now you should see the name of the extended Wi-Fi Network that you configured. Connect to the network by using the password that you configured.
Use WPS to Connect if you don't want to use any device
Connect your Macard WiFi extender to a power outlet located near your router. Watch for the LED to turn on.
Find the WPS button located on your main WiFi router. Hold the button down for 2 to 3 seconds. The WPS LED should begin blinking on the router.
Press and hold the WPS switch on the extender for 2-3 seconds within 2 minutes. The WPS LED on the extender should also start blinking.
Your devices may automatically connect to an extended network after a successful WPS. The credentials are often the same as your main WiFI to connect. If you cannot connect, manually connect to the original Wi-Fi. The extender will now broadcast a stronger signal.
How to place the Extender after completing the setup?
After you've finished setting up the Macard extender, you can unplug it and move it roughly halfway between the router and the location where you want better Wi-Fi coverage. Ensure it is still within the range of your router signal.
Troubleshooting tips for Setup
If one method of setup does not work, try another
If you are unable to connect, repeat the WPS procedure from step 2. Check that your router is WPS-enabled (some routers are disabled by default in newer models). Use the setup web-based method if WPS doesn't work.
Regularly update Extender Firmware
Updating the firmware can enhance performance and improve security. For the update of the extender's firmware, open the device interface by using IP 192.168.10.1. Find and open the Firmware tab in the Settings and click the UPDATE button.
Extender placement must be optimal
To extend the range, you need to place your extender where it can receive a strong signal from your router. The extended network will be weak if the signal between your router and extender are weak.
Factory reset if multiple issues occur at the same time
If you have multiple technical issues, it may be necessary to reset the extender back to its default factory settings. It is usually necessary to press and hold a small button with the word Reset on it, which can be found in a tiny pinhole. Hold the button for 10 seconds as you turn on the extender.
The End Words
You can eliminate dead zones and extend your WiFi with just a few taps of your Android device. You should have completed the installation by following the simple steps above.
